Belt Mod - Candy Toy KR OOO Belt and Weapon Set

Yesterday collected the belts ordered from Taobao... was pleasantly happy for most of the belts and snap buckles received, but the narrower belts (to be used for the candy toy belts) are a little too thick and can't be sewn with my normal-sized needle easily...

Anyway, manage to spend the whole evening, night, early morning for making a new belt for my little nephew's candy toy KR OOO belt and weapon set... Front of the set shown in below picture...


Added a simple strap-holster for the sword using velcro-straps and a part of a snap-assembly connector... holds quite well!


Just a picture to show the other side's view...


Retained the original belt buckle for length adjustment... Initially wanted to use the fabric strap's snap connector but this belt is too thick... Later use a part of this connector for making the sword holster part...  


Inside view of holster, adjustable along the belt...


Inside view of the O Scanner holder attaching to the belt... Barely adjustable along the belt, very tight...


Inner view of the buckle mod... Attached 2 white snap-assembly clips to mimic the original belt where both sides can be detached... All parts are connected with cable ties and wrapped up with silver-chromed tape...  a bit ugly...


Hope my little nephew likes it!