Modified the pin tabs of most of the Shift Cars that I have, for Kamen Rider Drive to have a "Power Up" Mode (although in the show Type High Speed is just Type Speed repaint itself to "motivate" Shinnosuke Tomari)!!! Hahahaha... Will be putting up some deco pieces on the Kamen Rider and Heisei 16 Riders cars to differentiate them from the (Ultra) Funky Spike and (Mega) Max Flare respectively...
The pins configuration... I used the ABS 2mm (or 2.5mm) sheet and painstakingly cut them into the pins before gluing them to place using superglue... Trimming has to be done... Unwanted original pins are cut off using wire-cutter and wood carving tool to trim nicely....
want to ask how did you get the pin code to be like that did you 3D print the parts and glue it on or did you open it all up 3D printed a part with all the clips and just clip out all the clips needed to make them into the other forms
Quite some time ago, cannot really remember, but I believe I scouted Youtube videos of the shift cars, pause at the scene where they show the back pins configuration and take a screenshot as reference. Read post above, it answers all your question how I do the pins...
TBH, Shift High Speed and Mega Max Flare both appeared in Kamen Rider Drive Hyper Battle DVD.
ReplyDeleteYeap, I know, hence my post above, but good infor for those who miss out on these 2 forms out to check them out.
Deletewant to ask how did you get the pin code to be like that did you 3D print the parts and glue it on or did you open it all up 3D printed a part with all the clips and just clip out all the clips needed to make them into the other forms
ReplyDeleteQuite some time ago, cannot really remember, but I believe I scouted Youtube videos of the shift cars, pause at the scene where they show the back pins configuration and take a screenshot as reference. Read post above, it answers all your question how I do the pins...
ReplyDelete